Agilent Technologies 7200 - 4 General Maintenance

67
Agilent 7200 Accurate-Mass Q-TOF GC/MS System
Troubleshooting and Maintenance Manual
Agilent Technologies
4
General Maintenance
Before Starting 68
To Refill the EI Calibration Vial 72
To Refill the IRM Vial 74
To Connect the GC Nitrogen Gas Source to the Collision Cell 76
To Replace the Seals in the RIS Probe 77
To Separate the GC from the MS 79
To Position the GC Next to the MS 82
To Move or Store the MS 83
This chapter describes maintenance procedures and requirements that are
used with all Agilent 7200 Accurate Mass Q-TOF GC/MS Systems.