5
Agilent 7697A Headspace Sampler
Installation and First Startup
Agilent Technologies
1
Installation
Before You Begin 6
Inspecting the Headspace Sampler 14
Place the Headspace Sampler on the Bench 15
Install the Configuration Plug 17
Install the Vial Tray (111 Vial Model Only) 21
Connect Cabling 26
Connect Gas Supplies 30
Connect the Transfer Line to the GC 35
Turn On the Headspace Sampler 49
Set the IP Address 50
Configure the Headspace Sampler 51
This guide describes how to install the Agilent 7697A
Headspace Sampler (HS). This guide assumes that the GC is
installed, configured, and operating properly, along with any
associated data system.
This chapter describes the installation steps to unpack and
install the instrument. The next chapter describes how to
start up the HS for the first time and verify it is operating
properly.
To Next Page
Loading...
Need help?
General
