First Startup 2
Installation and First Startup 63
Figure 20 Opening the tray cover
2 Start the sample run.
If using an Agilent data system:
a Set the injection source to be the HS.
b Create a 1 line sequence to run the checkout sample
(vial 1) once, using the checkout method.
c Set up the report so that the correct signal output
becomes part of the report.
d Start the sequence.
If using the HS standalone:
a Press [Sequence][Load/Append]. This creates the first
line of the sequence. Note that the default new
sequence line selects the current method, vial range 1
to 1, and 1 injection per vial. The sequence is
complete.
b When the GC is ready, press [Start] on the HS
keyboard.
To Next Page
Loading...
