7-9
Options and Accessories
Accessories Available
Verification Kit
85029B 7-mm verification kit
Includes attenuators and mismatch attenuator with data on a 3.5 inch disk for use in
confirming accuracy enhanced system measurement performance, traceable to national
standards. Test procedure is provided in the service guide. For use with a standard
8753ES, or with systems including an 8753ES Option 011 and an 85046A, or 85047A test
set. This verification kit may also be used with an 8753ET with the addition of two type-N
(m) to 7-mm adapters. The 85031B 7-mm calibration kit and 11857D test-port cables are
also required.
Minimum Loss Pads and Adapters
• 11525A 7-mm to 50 Ω type-N (m) adapter
Adapts from 7-mm to 50 Ω type-N male.
• 11852B 50 to 75 Ω minimum loss pad (300 kHz to 3 GHz)
Adapts from 50 Ω type-N female to 75 Ω type-N male. Nominal insertion loss is 5.7 dB.
— Option 004 provides 50 Ω type-N male and 75 Ω type-N female connectors.
• 11853A 50 Ω type-N accessory kit
Contains type-N (m) to type-N (m) adapters, type-N (f) to type-N (f) adapters, and
type-N male and female shorts.
• 11854A 50 Ω BNC accessory kit
Contains type-N to BNC adapters for both connector sexes and a BNC male short.
• 11855A 75 Ω type-N accessory kit
Contains 75 Ω type-N male to type-N male adapters, type-N female to type-N female
adapters, type-N male and female shorts, and type-N male termination.
To Next Page
Loading...
Need help?
General
