Appendix B 135
SCPI Command Reference
:CALC{1-4}:TRAN:TIME:STAR
:CALC{1-4}:TRAN:TIME:STAR
Syntax :CALCulate{[1]|2|3|4}[:SELected]:TRANsform:TIME:STARt <numeric>
:CALCulate{[1]|2|3|4}[:SELected]:TRANsform:TIME:STARt?
Description For the active trace of channel 1 (:CALC1) to channel 4 (:CALC4), sets the start value used
for the transformation function of the fault location function.
Parameters
If the specified parameter is out of the allowable setup range, the minimum value (if the
lower limit of the range is not reached) or the maximum value (if the upper limit of the
range is exceeded) is set.
Query response {numeric}<newline><^END>
Example of use 10 OUTPUT 717;":CALC1:TRAN:TIME:STAR 0"
20 OUTPUT 717;":CALC1:TRAN:TIME:STAR?"
30 ENTER 717;A
Related commands :CALC{1-4}:TRAN:TIME:STOP on page 139
:CALC{1-4}:TRAN:TIME:STAT on page 136
:CALC{1-4}:TRAN:DIST:STAR on page 120
Equivalent key [Analysis] - Fault Location - Start
<numeric>
Description Start value
Range Varies depending on the frequency span and the number of
points.
Preset value -1E-8
Unit s (second)
To Next Page
Loading...
