Agilent Technologies ENA Series

136 Appendix B
SCPI Command Reference
:CALC{1-4}:TRAN:TIME:STAT
:CALC{1-4}:TRAN:TIME:STAT
Syntax :CALCulate{[1]|2|3|4}[:SELected]:TRANsform:TIME:STATe {ON|OFF|1|0}
:CALCulate{[1]|2|3|4}[:SELected]:TRANsform:TIME:STATe?
Description For the active trace of channel 1 (:CALC1) to channel 4 (:CALC4), turns ON/OFF the
transformation function of the fault location function.
You can enable the transformation function only when the sweep type is the linear sweep
and the number of points is 3 or more. If you execute this command to try to enable the
transformation function when the sweep type is other than the linear sweep or the number
of points is less than 3, an error occurs and the command is ignored.
When the sweep type is the power sweep, you cannot turn on the transformation function.
If you execute this command trying to turn on the transformation function during the power
sweep, an error occurs and the command is ignored.
Parameters
Query response {1|0}<newline><^END>
Example of use 10 OUTPUT 717;":CALC1:TRAN:TIME:STAT ON"
20 OUTPUT 717;":CALC1:TRAN:TIME:STAT?"
30 ENTER 717;A
Related commands :CALC{1-4}:TRAN:DIST:STAT on page 121
Equivalent key [Analysis] - Fault Location - Fault Location
Description
ON or 1 Turns ON the transformation function.
OFF or 0 (preset value) Turns OFF the transformation function.