To Next Page

To Previous Page

6-25

Error Messages

ESG-D Series Signal Generator Instrument-Specific Error Messages

Init ignored;Sweep is already initiated.

Indicates that the list/sweep is currently initiated and sweeping, therefore the command

is not legal according to SCPI.

Init ignored;Sweep is already continuously initiated.

Indicates that the list/sweep is continuously initiated and sweeping, therefore the

command is not legal according to SCPI.

-221

Settings conflict;Cannot have uplink protocols while the control

frame is on. Frames 1-17 timeslots changed to downlink.

Indicates that, in TETRA mode, some of the timeslots are set to uplink. When the

control frame is turned on in TETRA, all timeslots in all frames must use downlink

protocols. The instrument enforces this by reconfiguring the timeslots that are not using

downlink protocols when the control frame is switched on.

Settings conflict;Cannot select uplink protocols while the

control frame is on. Selection changed to custom.

Indicates that in TETRA mode, an attempt has been made to select uplink protocols

while the control frame is switched on. TETRA requires that the control frame be

switched off in order to select uplink protocols.

Settings conflict;Continuous protocol timeslots cannot be turned

off.

Indicates that a continuous protocol timeslot is switched off while in TETRA mode.

When a continuous protocol has been selected for a timeslot in TETRA mode, all of the

timeslots must be switched on.

Settings conflict;Continuous & Discontinuous setting conflict.

All selected Continuous timeslots are now switched to

Discontinuous.

Indicates that while in TETRA mode, an attempt has been made to simultaneously

assign continuous and discontinuous protocols to the timeslots. Continuous and

discontinuous protocols cannot coexist in TETRA mode. If a discontinuous protocol is

selected for any timeslot, all timeslots’ protocols are changed to discontinuous

protocols.

Settings conflict;Discontinuous & Continuous setting conflict.

All selected Discontinuous timeslots are now switched to

Continuous.

Indicates that while in TETRA mode, an attempt has been made to simultaneously

assign discontinuous and continuous protocols to the timeslots. Discontinuous and

Agilent Technologies ESG-D Series User Manual

Other manuals for Agilent Technologies ESG-D Series