Service Guide N5230-90014 5-17
PNA Series Microwave Network Analyzers Theory of Operation
N5230A Signal Separation Group Operation
Normal Active Measurement Configuration
The normal active measurement configuration is shown in Figure 5-4. This configuration
includes Option 014, configurable test set, and Option 1E1, source step attenuators. With
this configuration and inclusion of an external amplifier and accessories, you can calibrate
the analyzer and test devices at power levels up to +30 dBm. You can make measurements
in the forward, reverse or both directions and still achieve these high power levels. For
more information on higher power measurements, search for “Option 014” in the
embedded help index in the analyzer.
Figure 5-4 Normal Active Measurement Configuration
To Next Page
Loading...
Need help?
General
