41
MAIN
MAIN SCREEN
When a project is loaded, pressing the MAIN SCREEN key will show this screen:
You can see an overview of the project plus level metering of inputs, the eight groups, the FX sends and returns and
disk tracks. You may zoom in/out on the GRID overview horizontally by pressing SHIFT+ </> (you cannot zoom in
vertically).
The soft keys’ functions are as follows:
T/C DISPLAY Selects ABS(olute) or REL(ative) time display in the dedicated timecode display.
COUNTER RESET When REL timecode display is selected, you can reset it to 00:00:00:00 at any point.
CYCLE Switches the CYCLE function on or off. When it is switched on, loop playback is pos-
sible between the IN and OUT markers.
➸
NOTE :
Cycle playback is not seamless and there will be a pause as the region cycles.
METERS Allows you to select whether metering is pre-EQ, pre-fader or post-fader.
METRO Switches the metronome on/off. When ON, the metronome is heard through the MONI-
TOR OUT and HEADPHONES output. The BPM and time signature of the metronome
is governed by the TEMPO MAP (see later - SETUP/TEMPO). The level of the metro-
nome is set in SETUP/PREFS.
VARI Switches VARISPEED on or off. You can use Q6 to the key’s right to set the varispeed
amount. This can be switched on or off and adjusted in real-time as the project is play-
ing.
To Next Page
Loading...
Need help?
General
