Akai EWI 4000S

EWI4000s Operator’s Manual rev 1.0
2
Chapter1: Introduction
Parts’ Names and Functions
Hold Button: This button is used to
go into HOLD mode or works as the
Program Up function. Pressing this
button turns the LED on and enables
the specified function. It also works as
“+”(Increase) button in Setup mode.
MOUTH PIECE: Hold the tip
of the Mouthpiece and blow
to play-much like a traditional
woodwind instrument. There
is vibrato sensor in the Mouth-
piece. You can produce a vi-
brato effect by gently biting
the Mouthpiece. Do not bite
too hard.
Octave Button : This button is
used to activate the OCTAVE mode
or works as the Program Down func-
tion. Pressing this button turns the
LED on and enables the specified
function. It also works as “
- ”(In-
crease) button in Setup mode.
Note Keys (with Touch Sensors):
These keys decide the note.
The three low keys can be ad-
justed the finger position by
loosening its screw.
Top Panel
This chapter describes the name of each part and its function.