EWI4000s Operator’s Manual rev 1.0
27
Adjusting the Delay effect volume of each program
This procedure adjusts the Delay effect volume of each Program. This will only affect
the Delay effect volume of the selected program but does not affect the overall Reverb
effect volume. The Delay effect volume setting of each program is stored in the
EWI4000s.
1. Select the program you wish to adjust the Delay effect volume.
2. While pressing the [FX] button, press the
[SETUP] button.
While pressing both the
[FX] button and [SETUP]
button, “rb” is shown on
the Program/Data display.
3.
While pressing the [SETUP] button, release the [FX] button, and then press
the [HOLD] button so that the Program/Data display now shows “dL” .
When you release both the [SETUP] button and the [HOLD] but-
ton while “dL” is shown, the current Delay volume of the selected
program will be shown on the Program/Data display.
4.
Adjust the Delay volume by pressing the [HOLD] button or the [OCT] button.
The [HOLD] button works as ( + ), and the [OCT] button works as ( - ).
5. Press the [SETUP] key.
The EWI4000s returns to the “PLAY” mode
To Next Page
Loading...
