EWI4000s Operator’s Manual rev 1.0
5
C: Bend Plate part
(1) Neck strap Mount
Hang the EWI4000s on a Neck strap (included) to
make your playing easier.
(2) Program key (with a touch sensor)
It changes the Program (internal sound). By touch-
ing this key without touching any note keys, the se-
lected Program number is shown on the Program/
Data display, and then you can change the Program
number by using the [HOLD] or the [OCT] button.
(3) Bend Up Plate (with a touch sensor)
Touching this key raises the pitch. You can adjust
the position of the plate by loosening its screw.
(4) Bend Down Plate (with a touch sensor)
Touching this key lower the pitch. You can adjust
the position of the plate by loosening its screw.
(5) Earth Plate for right hand (with a touch sensor)
Always keep either your thumb on the Earth plate while playing
(6) FX (Effect) button
Pressing this button shows the overall Reverb level on the Program/Data display, and
then you can change the level by using the [HOLD] or the [OCT] button.
(7) LEVEL button
Pressing this button shows the Main Output level on the Program/Data display, and
then you can change the level by using the [HOLD] or the [OCT] button
(8) Touch Sensor Sensitivity Adjustment knob
Adjustment knob for Touch sensor keys. It is very important to set this correctly. See
page 18 to set this up properly.
To Next Page
Loading...
