EWI4000s Operator’s Manual rev 1.0
46
Chapter4:
Using the EWI4000s as a MIDI Controller
Initialize to Factory Preset
By turning the EWI4000s on while holding the [LEVEL], [FX], [SETUP], and [TRANS]
buttons, the EWI4000s is reset to the Factory Preset setting.
The following global settings are stored in EWI4000s.
dL : Key delay:02
CH: Midi channel:01
tu : Tune:40
bS : Breath sensor:Only expression is set.
vS : Vibrato sensor:Only expression is set.
vE : Velocity:120
Po : Portamento:on
Oc : Octave key:OF
Ho : Hold key:OF
GL : Glide:r
Level master:30
Level preset:30
Reverb master:21
- Effect preset -
CH: Chorus:OF
dL : Delay:OF
rb : Reverb:21
To Next Page
Loading...
