EWI4000s Operator’s Manual rev 1.0
14
Chapter2: Basic Operation
Sensor Sensitivity Adjustment
To fully use the instrument’s various performance features, you should properly adjust
BREATH, GLIDE, BEND, and VIBRATO sensors for your own performing requirements.
Note: Each sensor has been adjusted properly in the factory. However, adjust them again by
yourself before you play it. The sensor adjustment may be changed as you prefer.
The knobs for Sensor Sensitivity Adjustment are located under the cover
just above the Program/Data display. Remove the cover as shown in
the drawing.
You will need to be in “SET UP” mode to adjust the Sensor Sensitivity.
1. Press the [SETUP] button
2. The LED will light up, indicating that “SET UP” mode is activated.
In the SET UP mode, each LED on the Program/Data display works as the indicator of
each sensor.
The function of each knob is as follows:
Glide Sensor adjustment
Knob (A)
Pitch Bend Sensor adjustment
Knob
(A)
Vibrato Depth adjustment
Knob (A)
Breath Sensor adjustment
Knob (A)
Glide Time setting Knob (T)
Breath Sense Knob (S)
Pitch Bend Width Knob (W)
To Next Page
Loading...
