EWI4000s Operator’s Manual rev 1.0
28
Chapter3:
Playing EWI4000s with Internal Sound
Adjusting the Chorus effect On/Off on each program
This prcedure selects whether the Chorus effect is set to On or Off for each program.
The Chorus effect setting of each program is stored in the EWI4000s.
1. While pressing the [FX] button, press the [SETUP] button.
While pressing both the [FX] button and [SETUP] button, “rb” is shown on the
Program/Data display.
2. While pressing the [SETUP] button, release the [FX] button, and then
press the [HOLD] button so that the Program/Data display shows “CH” .
When you release both the [SETUP] button and the [HOLD] button while “CH” is
shown, the current Chorus setting of the se-
lected program will be shown on the Program/
Data display.
3. Select the Chorus to either “on” or
“OF” by pressing the [HOLD] button
or the [OCT] button.
If you select “on”, the chorus effect is active on the selected program.
4. Press the [SETUP] key.
The EWI4000s returns to the “PLAY” mode.
To Next Page
Loading...
