EWI4000s Operator’s Manual rev 1.0
47
Specifications
EWI4000s Specifications
Type Wind-instrument type controller with sound module
Fingering Saxophone fingering and EWI fingering
Sensors Note Keys: touch sensors
Mouthpiece Breath: air pressure level sensor
Lip: pressure level sensor
Bend Up/Down Plates: touch sensors
Glide Plate: touch sensor
Octave Shift Rollers: touch sensors
Program key touch sensor
Keys "LEVEL key, FX key, SETUP key, TRANSPOSE key OCT key, HOLD key"
Sensor Adjustment "Breath Sense, Breath Adjustment, Bend Width, Bend Adjustment,"
"Glide Time, Glide Adjustment, Vibrato Adjustment"
Terminals LINE OUT x 1 (1/4 inch Phone Jack)
"Headphones OUT x 1 (Dual Mono, Stereo Mini Jack,)"
(The recommended minimum headphone impedance is 32 ohoms)
"MIDI IN x 1, MIDI OUT x 1 (5-pin DIN)"
DC IN x 1 (for optional AC adaptor MP-9II)
Other Removal Cable Clutch
Power requirement
AA (ALKALINE or Rechargeable) battery x 4
( Approx. 8 hours continuous use by batteries except using Headphones)
or 9VDC/200mA AC-adaptor MP-9II (Optional)
Dimensions 670.5mm(L) x 61mm(W) x 69mm(D)
Weight 874g (not included Batteries)
Accessories "Operator's Manual, Neck strap, AA battery x 4, Cleaning Cloth, Mouthpiece Cover"
Sound module
Sound type Analog Modeling Synthesizer
Voices 2 (only while Octave & Hold function)
Control range 8 octaves
Sound Source "2 x Oscillator, 2 x Filters"
"Waveforms: Saw Tooth, Triangle, Pulse "
"Noise Generator, Formant filter"
Effect "Reverb, Delay, Chorus"
Sound Capacity 100 ( 50 preset sound x 2)
Display 7-segment LED x 2
Function "Transpose, Tune, Note Hold, Octave, Program Change, Key Delay"
Other Sound Editor software for EWI4000s is available from our Web site
Above specifications and appearance are subject to change without notice.
To Next Page
Loading...
