Akai EWI 4000S

EWI4000s Operator’s Manual rev 1.0
23
Alternate way of Selecting the Program number
Selecting a Program number without touching the [Program] key
Selecting Programs is usually done by touching the [Program] key. But the EWI4000s
allows you to change programs by pressing the [HOLD] button or the [OCT] button with
the following setting. It may be convenient when you need to change the program num-
ber during while playing a song. In this way, the [HOLD] button or [OCT] button works
as the Program number Up or the Program number Down, instead of the [HOLD] func-
tion or the [OCT] function.
While “UP” is selected, the [HOLD] button works as the Program number Up.
5. Press the [SETUP] button.
The EWI4000s returns to the “PLAY” mode.
Program Up with the [HOLD] button
Note: While this setting is done, you cannot use the [HOLD] function.
1. Press the [SETUP] button.
While pressing the [SETUP] button, “Ad” is shown on
the Program/Data display.
2. While pressing the [SETUP] button, select
“Ho” (Hold) by pressing the [HOLD] button.
It allows you to select the setup parameter by
pressing the [HOLD] or the [OCT] button while
pressing the [SETUP] button.
3. After selecting “Ho”, release the [SETUP] button.
4. Select the “UP” by pressing the [HOLD] button or the [OCT] button