Akai EWI 4000S

EWI4000s Operator’s Manual rev 1.0
24
Chapter3: Playing EWI4000s with Internal Sound
Program Down with the [OCT] button
Note: While this setting is done, you cannot use the Octave function.
1. Press the [SETUP] button.
While pressing the [SETUP] button, “Ad” is shown on
the Program/Data display.
2. While pressing the [SETUP]
button, select “Oc” (Octave)
by pressing the [OCT] button.
It allows you to select the setup parameter by
pressing the [HOLD] or the [OCT] button while
pressing the [SETUP] button.
3. After selecting “Oc”, release the [SETUP]
button.
4. Select “dn” (down) by using the [HOLD] button or the [OCT] button
While “dn” is selected, the [OCT] button works as the Program number Down.
5. Press the [SETUP] button.
The EWI4000s returns to “PLAY” mode
With the above setting, you can change the Program number only while using the
[HOLD] button or the [OCT] button without touching the [Program] key.
When you press either the [HOLD] or the [OCT] button, the current Program num-
ber will be shown on the Program/Data display, and then continuing to press the
[HOLD] button will continue the Program number Up , and continuing to press the
[OCT] button will continue the Program number Down.
You can set only either the [HOLD] or the [OCT] button as the Program Up or the
Program Down. In this case, you can do both Program Up and Down by using both
the [HOLD] and the [OCT] button.
When you are using the [HOLD] button as the Program Up and the [OCT] button as
the Octave function, while pressing the [HOLD] button, the [OCT] button works as
the Program Down. For Example, when selecting the Program number “10”, if you
press the [HOLD] button, the Program will be changed to “11”, then if you press the
[OCT] button while pressing the [HOLD] button, the Program will be changed to
“10”, and if you press the [OCT] button again, the Program will be changed to “9”.