EWI4000s Operator’s Manual rev 1.0
41
The LED “dot”will need to be lit to transmit its MIDI event..
If the LED “dot” is not lit, the EWI4000s will not transmit its MIDI event.
You can select several MIDI events to transmit at the same time.
If you select ”vE”, you can transmit the MIDI Velocity data by your breath strength.
5. Press the [SETUP] button.
The EWI4000s returns to the “PLAY” mode.
Note: If you press any button other than the [SETUP], [TRANS], [HOLD], or [OCT] but-
ton, your setting MIDI event is ignored and it returns to the original setting.
To Next Page
Loading...
