Akuvox R26 Series - No Answer Call; Multicast; Push to Hang up

R26/R23 Series
Admin Guide
17
3.4.5. No Answer Call
Go to Intercom - Basic and enable the no answer call.
Go to Intercom - Basic and set the no answer call number.
3.4.6. Multicast
Go to Intercom - Multicast to configure.
Paging Barge: Choose the multicast number, the range is 1-10.
Paging priority Active: Enable to disable the multicast.
Listening Address: Enter the IP address users need to listen.
Label: Input the label for each listening address.
3.4.7. Push To Hang Up
Go to Intercom - Basic to configure. To enable or disable pushing
button to hang up.
Figure 3.4.6 Multicast
Figure 3.4.7 Push to hang up
Figure 3.4.5-1 No Answer call
Figure 3.4.5-2 No answer call