HP106/HP406 Programmer software guide
Ver. 1.0 Page 5
2 INSTALLATION
2.1 Unpacking
The following items are in the programmer’s package:
(a) CD with the programming software
(b) Programming operating instructions (this book!)
(c) Connection cable (serial to transceiver’s service port)
If something is missing please promptly advise your supplier.
2.2 System requirements
To use the CTE Programming Software for HP106 you need the following hardware and software:
(a) IBM-compatible personal computer with Pentium (I) processor or higher (basically depending on the operating system)
(b) Operating system Windows 95 or higher.
(c) Hard drive - at least 2MB of free disk space and CD drive
(d) Random access memory (RAM) - basically depending on the O.S. (at least 32 MB; 64 MB recommended)
2.3 Installing programming Software
Setting up your programming software is easy and fast, thanks to the Installing Wizard, a step-by-step installing program. Just
please follow these steps.
Steps can be slightly different according to the O.S. you are using
1) Start Windows, if it is not already running.
2) Insert the CD with the software in your drive.
3) Click the Start button, click Run: you will see the “Run” dialog box.
4) Type D:\setup.exe
(where D: indicates your CD drive) or click the Browse button and use the “Browse” commands in order to select the
said path and the executable (.exe) file.
5) Click OK and then follow the instructions which appear.
6) While installing, you will see a window asking you to read the software license agreement. Click YES button to accept them and continue
installing.
Should you want to use the software, you should accept the license agreement by clicking Yes button, otherwise, if you click No, the set-
up will be automatically interrupted.
7) Several windows will ask you to insert your user’s information, choose a destination location for the program and finally select the
program folder. To accept the default information and go ahead with the next window click NEXT> button.
8) When installation is complete, the HPx06 programmer’s icon appears in Start – Programs – HPx06 folder
If in the installing procedure you’ll get error messages, copy the software in a temporary directory on your hard disk (e.g. C:\temp), then
retry installing the software from the hard disk instead from the CD
Please see your computer’s operating instructions if you need help.
To Next Page
Loading...
