Alcatel-Lucent 1830 PSS-16 - Page 534

...................................................................................................................................................................................................
3
Remove the pluggable module from the port on the card it is inserted in. Examine the
connector on the SFP and the receptacle connector on the card where the SFP plugs into
for any damage. If no damage is seen, reinsert the pluggable module into its port.
...................................................................................................................................................................................................
4
Remove and replace the pluggable module with another unit of the same type, being
careful with the connected fiber jumpers. Refer to “Replacing an SFP Module” (p. 3-27).
...................................................................................................................................................................................................
5
Perform a cold reset of the card on the card where the pluggable module failure is raised.
CLI config card card_type shelf slot reset cold
WEBUI Select the card, click the Reboot tab, select Cold Reboot >Submit.
...................................................................................................................................................................................................
6
Reseat the card. Refer to “Reseating a Card” (p. 3-19).
...................................................................................................................................................................................................
7
Replace the card. Refer to “Replacing System Components” (p. 3-20).
RFIEGR
RFIEGR (Remote Client Remote Fault)
The OT port has detected a Remote Fault Identifier (RFI) ordered set on the 10GbE LAN
service transported over the OTUk in the transmit direction.
This may be caused if the remote client equipment is generating RFI ordered sets.
Severity NA
Service affecting? No
Applicability 11QPA4, 11STAR1, 43STX4
This procedure details the corrective action for clearing RFIEGR declared on an OT port.
...................................................................................................................................................................................................
1
Locate far end OT.
Trouble-clearing procedures
REPLUNITMISSMOD
REPLUNTMISS (Pluggable Module Missing)
....................................................................................................................................................................................................................................
....................................................................................................................................................................................................................................
2-284
1830 PSS-36/PSS–32/PSS-16/PSS-4
8DG60888CAAA Release 3.6.0 and 3.6.1
Issue 1 June 2011
E ND OF STEPS
...................................................................................................................................................................................................