Interface Configuration
7210 SAS M, T, X, R6, R12, Mxp Interface Configuration Guide Page 103
Configuring Ethernet Port Parameters
Ethernet Network Port
A network port is network facing and participates in the service provider transport or
infrastructure network processes. The following example displays a network port configuration:
A:ALA-B>config>port# info
----------------------------------------------
description "Ethernet network port"
ethernet
mode network
exit
no shutdown
----------------------------------------------
A:ALA-B>config>port#
Ethernet Access uplink Port
Access-uplink port are network facing and transport customer service. It allows only QinQ
encapsulation to be used.
A:ALA-B>config>port# info
----------------------------------------------
description "Ethernet network port"
ethernet
mode access uplink
exit
no shutdown
----------------------------------------------
A:ALA-B>config>port#
Ethernet Access Port
Services are configured on access ports used for customer-facing traffic. If a Service Access Port
(SAP) is to be configured on a port, it must be configured as access mode. When a port is
configured for access mode, the appropriate encapsulation type can be specified to distinguish the
services on the port. Once a port has been configured for access mode, multiple services may be
configured on the port.
The following example displays an Ethernet access port configuration :
*A:7210-SAS>config>port# info
----------------------------------------------
ethernet
To Next Page
Loading...
