Configuring Ports
Page 108 7210 SAS M, T, X, R6, R12, Mxp Interface Configu-
ration Guide
Configuring LAG Parameters
LAG configurations should include at least two ports. Other considerations include:
• A maximum of four ports can be included in a LAG. All ports in the LAG must share the
same characteristics (speed, duplex, hold-timer, etc.). The port characteristics are inherited
from the primary port.
• Autonegotiation must be disabled or set limited mode for ports that are part of a LAG to
guarantee a specific port speed.
• Ports in a LAG must be configured as full duplex.
The following example displays LAG configuration output:
*A:7210SAS>config>lag# info detail
----------------------------------------------
no mac
mode hybrid
encap-type dot1q
no enable-dei
port 6/1/1 priority 32768 sub-group 1
no dynamic-cost
lacp active administrative-key 32770
port-threshold 0 action down
lacp-xmit-interval fast
lacp-xmit-stdby
no selection-criteria
no hold-time
standby-signaling lacp
no shutdown
----------------------------------------------
*A:7210SAS>config>lag#
To Next Page
Loading...
