Alcatel-Lucent 7210 SAS M - LAG Hashing Fields used for 7210 SAS-T Access-Uplink mode

Interface Configuration
7210 SAS M, T, X, R6, R12, Mxp Interface Configuration Guide Page 55
2. Source/Destination MAC refer to ‘Customer Source/Destination MACs’ unless otherwise
specified.
3. VLAN ID is considered for Learnt - PBB, MPLS, Non-IP traffic in VPLS service only
for traffic ingressing at dot1q, Q.*, Q1.Q2 SAPs.
4. Only outer VLAN tag is used for hashing.
LAG Hashing Fields used for 7210 SAS-T Access-Uplink mode
Table 10: LAG Hashing mechanism for services configured on 7210 SAS-T Access-Uplink mode
Services and Traffic Direction Packet fields used for Hashing for different
traffic types
VPLS service:
SAP to SAP
IP traffic (Learnt): Source and Destination IP,
Source and Destination L4 ports.
IP traffic (Unlearnt): Source and Destination
IP, Source and Destination L4 ports, Ingress
Port-Id
PBB traffic (Learnt): BDA, BSA, VLAN
PBB traffic (Unlearnt): BDA, BSA, ISID,
Ingress Port-Id
MPLS traffic (Learnt): Source and Destination
MAC (Outer MACs of the Ethernet packet
that encapsulates MPLS packet)
MPLS traffic (Unlearnt-IP): MPLS label stack
(Two labels deep), Source and Destination IP,
Ingress Port-Id, VLAN
MPLS traffic (Unlearnt-L2): MPLS label
stack (Two labels deep), Ingress Port-Id
Non-IP traffic (Learnt): Source and
Destination MAC, EtherType, VLAN
Non-IP traffic (Unlearnt): Source and
Destination MAC, EtherType, Ingress Port-Id,
VLAN