Alcatel-Lucent 7210 SAS M Interface Configuration Guide

LAG
Page 56 7210 SAS M, T, X, R6, R12, Mxp Interface Configu-
ration Guide
NOTE:
1. The term ‘Learnt’ mentioned corresponds to Destination MAC.
2. Source/Destination MAC refer to ‘Customer Source/Destination MACs’ unless otherwise
specified.
3. VLAN ID is considered for Learnt - PBB, MPLS, Non-IP traffic in VPLS service only
for traffic ingressing at dot1q, Q.*, Q1.Q2 SAPs.
4. Only outer VLAN tag is used for hashing.
Epipe service:
SAP to SAP
IIP traffic: Source and Destination IP, Source
and Destination L4 ports, Ingress Port-Id.
PBB traffic: BDA, BSA, ISID, Ingress Port-Id
MPLS traffic (IP): MPLS label stack (Two
labels deep), Source and Destination IP,
Ingress Port-Id
MPLS traffic (L2): MPLS label stack (Two
labels deep), Ingress Port-Id
Non-IP traffic: Source and Destination MAC,
EtherType, Ingress Port-Id, VLAN
IES service (IPv4):
IES SAP to IES SAP
IPv4 unicast traffic: Source and Destination
IP, Source and Destination L4 ports.
Table 10: LAG Hashing mechanism for services configured on 7210 SAS-T Access-Uplink mode
Services and Traffic Direction Packet fields used for Hashing for different
traffic types

Alcatel-Lucent 7210 SAS M Specifications

General

Brand	Alcatel-Lucent
Model	7210 SAS M
Category	Switch
Language	English