Service Management Tasks
Page 110 7210 SAS M, T, X, R6, R12, Mxp Interface Configu-
ration Guide
Service Management Tasks
This section discusses basic procedures of the following service management tasks:
• Modifying a Card Type on page 111
• Deleting a Card on page 112
• Deleting Port Parameters on page 112
To change an MDA type already provisioned for a specific slot/card, first you must shut down the
slot/MDA/port configuration and then delete the MDA from the configuration. Modify and delete
operations can be performed only on the MDAs that are not auto equipped or auto provisioned.Use
the following CLI syntax to modify an MDA:
CLI Syntax: config> port port-id
shutdown
CLI Syntax: config> card slot-number
shutdown
[no] mda mda-number
[no] mda-type mda-type
shutdown
To Next Page
Loading...
