Alcatel-Lucent 7210 SAS M - LAG Hashing Fields used for 7210 SAS-M (Access-Uplink mode)

LAG
Page 54 7210 SAS M, T, X, R6, R12, Mxp Interface Configu-
ration Guide
LAG Hashing Fields used for 7210 SAS-M (Access-Uplink mode)
NOTE:
1. The term ‘Learnt’ mentioned corresponds to Destination MAC.
Table 9: LAG Hashing mechanism for services configured in Access-Uplink mode on 7210 SAS-M
Services and Traffic Direction Packet fields used for Hashing for different traffic
types
VPLS service:
SAP to SAP
IP traffic (Learnt): Source and Destination IP, Source
and Destination L4 ports.
IP traffic (Unlearnt): Source and Destination IP,
Source and Destination L4 ports, Ingress Port-Id
PBB traffic (Learnt): BDA, BSA, VLAN
PBB traffic (Unlearnt): BDA, BSA, ISID, Ingress
Port-Id
MPLS traffic (Learnt): Source and Destination MAC
(Outer MACs of the Ethernet packet that encapsulates
MPLS packet), VLAN
MPLS traffic (Unlearnt): MPLS label stack (Two
labels deep), Ingress Port-Id
Non-IP traffic (Learnt): Source and Destination
MAC, EtherType, VLAN
Non-IP traffic (Unlearnt): Source and Destination
MAC, EtherType, Ingress Port-Id, VLAN
Epipe service:
SAP to SAP
IP traffic: Source and Destination IP, Source and
Destination L4 ports, Ingress Port-Id.
PBB traffic: BDA, BSA, ISID, Ingress Port-Id
MPLS traffic: MPLS label stack (Two labels deep),
Ingress Port-Id
Non-IP traffic: Source and Destination MAC,
EtherType, Ingress Port-Id, VLAN
IES service (IPv4):
IES SAP to IES SAP
IPv4 unicast traffic: Source and Destination IP,
Source and Destination L4 ports.