To Next Page

To Previous Page

Interface Configuration

7210 SAS M, T, X, R6, R12, Mxp Interface Configuration Guide Page 89

Deploying Pre-provisioned Components for 7210 SAS-M, 7210

SAS-X, 7210 SAS-T, and 7210 SAS-Mxp.

Appropriate MDAs are auto-provisioned in 7210 SAS-M, 7210 SAS-X, 7210 SAS-T, and 7210

SAS-Mxp devices. User is not required to provisions the slots or MDA on these platforms.

Deploying Pre-provisioned Components for 7210 SAS-R6 and

7210 SAS-R12

When a line card/MDA is installed in a pre-provisioned slot, the device detects discrepancies

between the pre-provisioned card and MDA type configurations and the types actually installed.

Error messages display if there are inconsistencies and the card will not initialize.

When the proper pre-provisioned card are installed into the appropriate chassis slot, alarm, status,

and performance details will display.

The 7210 SAS-R6 devices has 6 IMM slots and 2 SF/CPM slots which are not auto-provisioned

and needs to be provisioned by the user.

The 7210 SAS-R12 devices has 12 IMM slots and 2 SF/CPM slots which are not auto-provisioned

and needs to be provisioned by the user.

NOTE: 7210 SAS-R6 does not support a mix of imm-sas-r (IMMv1) and imm-sas-r-b (IMMv2)

cards in the same chassis. In other words, user can either have all cards in the chassis to be of type

IMMv1 or all the cards to be of type IMMv2, a mix and match of IMMv1 and IMMV2 cards in the

same chassis is not allowed.

On 7210 SAS-R6, the user is provided with a command to pre-provision the chassis to accept

either IMMv1 or IMMv2 cards. By default, without any configuration, the chassis accepts only

IMMv1 cards. User must use the command configure> system> allow-imm-family to configure

the type of card the chassis can accept and reboot the device for the value to take effect. For more

information on this command, see the “7210 SAS Basic Systems Configuration User Guide”.

The 7210 SAS-R12 does not support imm-sas-r (IMMv1), it supports only imm-sas-r-b (IMMv2)

cards.

NOTE: The CLI command allow-imm-family is not supported on 7210 SAS-R12, as there is no

need to pre-provision the chassis. It only accepts IMMv2 card (imm-sas-r-b).

Alcatel-Lucent 7210 SAS M Interface Configuration Guide

Other manuals for Alcatel-Lucent 7210 SAS M