Generic Commands
Page 134 7210 SAS M, T, X, R6, R12, Mxp Interface Configuration
Guide
Values 7210 SAS-R6 - imm-sas-10sfp+1xfp|imm-sas-10sfp|imm-sas-2xfp| imm-sas-b-
4sfp+|imm-sas-b-2sfp+|imm-sas-b-10sfp-1sfp+| imm-sas-b-11csfp|imm-sas-b-16tx
7210 SAS-R12 - imm-sas-b-4sfp+|imm-sas-b-4xfp|imm-sas-b-2sfp+| imm-sas-b-10sfp-
1sfp+|imm-sas-b-11csfp|imm-sas-b-16tx
sys-res-profile
Syntax [no] sys-res-profile policy-id
Context config>card
Description This CLI command provides the context to the attach the system resource-profile policy. It is supported only
on 7210 SAS-R6 and 7210 SAS-R12. On 7210 SAS-R6 and 7210 SAS-R12 devices, the system resource
profile parameters are defined as a policy. User needs to configure the system resource profile policy and
associate it with the IMM card. The software reads the configured policy and allocates resources
appropriately per IMM card. It allows users to allocate resource to different features per IMM card.
NOTE: On 7210 SAS-R6 and 7210 SAS-R12, some of the system resource profile parameters are applicable
to the entire node and not per IMM card.
For more information on the CLI descriptions for System Resource Profile parameters, see the 7210 SAS-M,
T, X, R6, R12, Mxp Basics System Guide.
Default By default, the system attaches the default system resource-profile to each IMM when it is booted up.
Parameters policy-id — Specifies the system resource profile policy to use for this card.
Values [1-16]
To Next Page
Loading...
Need help?
General
