Alcatel-Lucent 7210 SAS M - Page 144

Interface Configuration
7210 SAS M, T, X, R6, R12, Mxp Interface Configuration Guide Page 139
qos
Syntax qos policy-id
no qos
Context config>port>ethernet>access>egress
config>port>ethernet>access>uplink
Description
This command associates a access-egress QoS policy to the access port.
On 7210 SAS-X, 7210 SAS-R6 and 7210 SAS-R12, this policy is used to enable port-based marking and
configure values to use marking.
Parameters policy-id — Specifies an existing QoS policy to be assigned to the port.
Values 1 — 65535
qos
Syntax qos policy-id
no qos
Context config>port>ethernet>network
Description This command associates a network QoS policy.
Parameters policy-id — Specifies an existing QoS policy to be assigned to the port.
Values [1|3..65535]
sap-qos-marking
Syntax sap-qos-marking {enable | disable}
no sap-qos-marking
Context config>port>ethernet>access>egress
Description Platforms Supported: 7210 SAS-X.
This command allows the user to enable and disable port based egress marking for all the SAPs configured
on an access port and hybrid port.
Note: This command is supported only on 7210 SAS-X. It is not supported on 7210 SAS-M, SAS-T, 7210
SAS-Mxp, 7210 SAS-R6 and 7210 SAS-R12 devices.