Ethernet Port Commands
Page 156 7210 SAS M, T, X, R6, R12, Mxp Interface Configuration
Guide
for the port. One use for limited mode is for multispeed gigabit ports to force gigabit operation while
keeping autonegotiation enabled for compliance with IEEE 801.3.
7210 SAS requires that autonegotiation be disabled or limited for ports in a Link Aggregation Group to
guarantee a specific port speed.
The no form of this command disables autonegotiation on this port.
Default autonegotiate
Parameters limited — The Ethernet interface will automatically negotiate link parameters with the far end, but will only
advertise the speed and duplex mode specified by the Ethernet
speed and duplex commands.
connection-type
Syntax connection-type
Context config>port>ethernet
Description Platforms Supported: 7210 SAS-Mxp
This command configures the connection type on the ethernet combo port. The combo port provides two
physical interface options to the user - sfp or copper. This command lets the user specify the physical
interface that will be used.
When configured as SFP port it allows for fiber based connectivity with the flexibility of using suitable
optics for longer reach. When configured as a fixed copper port it provides cheaper connectivity for shorter
reach. The SFP port support 100/1000 speeds and the copper port can support 10/100/1000Mbps speed.
The combo port can be configured either as a SFP port or a copper port. In other words, both the interfaces
cannot be used simultaneously.
Default sfp
Parameters connection-type — Specifies the type of ethernet combo port.
Values sfp | copper | auto
crc-monitor
Syntax crc-monitor
Context config>port>ethernet
Description This command configures Ethernet CRC Monitoring parameters.
Default none
To Next Page
Loading...
Need help?
General
