Ethernet Port Commands
Page 170 7210 SAS M, T, X, R6, R12, Mxp Interface Configuration
Guide
9. Disable loop back and execute the command config >port>ethernet> no loopback internal.
10. Enable the port and execute the command config>port> no shutdown.
11. Enable the required services.
Parameters service <service-id> — The unique service identification number or string identifying the service in the
service domain. This ID must be unique to this service and may not be used for any other service of any
type. The service-id must be the same number used for every on which this service is defined.
Values service-id 1 — 2147483648
sap <sap-id> — Specifies the physical port identifier portion of the SAP.
Values sap-id null - <port-id>
qinq
- <port-
id>:qtag1.qtag2
port-id - slot/mda/port[.channel]
id - [1..1000]
qtag1 - [0..4094]
qtag2 - [*|1..4094]
Values
src-mac <SA> — Specifies the source MAC address.
Values SA 6-byte unicast mac-address (xx:xx:xx:xx:xx:xx or xx-xx-xx-xx-xx-xx).
dst-mac <DA> — Specifies the destination MAC address.
Values DA 6-byte unicast mac-address (xx:xx:xx:xx:xx:xx or xx-xx-xx-xx-xx-xx).
ssm
Syntax ssm
Context config>port>ethernet
Description This command enables Ethernet Synchronous Status Message (SSM).
code-type
Syntax code-type [sonet | sdh]
Context config>port>ethernet>ssm
Description This command configures the encoding of synchronous status messages, that is, to select either SDH or
SONET set of values. Configuring the code-type is only applicable to Synchronous Ethernet ports. It is not
configurable on TDM ports. For the code-type, SDH refers to ITU-T G.781 Option-1,while SONET refers to
G.781 Option 2 (equivalent to Telcordia GR-253-CORE).
Default sdh
To Next Page
Loading...
Need help?
General
