LLDP Ethernet Port Commands
Page 178 7210 SAS M, T, X, R6, R12, Mxp Interface Configuration
Guide
The no form of the command disable LLDP tunneling for frames using nearest-bridge destination MAC
address.
Default no tunnel-nearest-bridge-dest-mac
dest-mac
Syntax dest-mac {bridge-mac}
Context config>port>ethernet>lldp
Description This command configures destination MAC address parameters.
Parameters bridge-mac — Specifies destination bridge MAC type to use by LLDP.
Values nearest-bridge — Specifies to use the nearest bridge.
nearest-non-tpmr — Specifies to use the nearest non-Two-Port MAC Relay (TPMR) .
nearest-customer — Specifies to use the nearest customer.
admin-status
Syntax admin-status {rx | tx | tx-rx | disabled}
Context config>port>ethernet>lldp>dstmac
Description This command specifies the desired administrative status of the local LLDP agent.
Parameters rx — Specifies the LLDP agent will receive, but will not transmit LLDP frames on this port.
tx — Specifies that the LLDP agent will transmit LLDP frames on this port and will not store any
information about the remote systems connected.
tx-rx — Specifies that the LLDP agent transmitw and receives LLDP frames on this port.
disabled — Specifies that the LLDP agent does not transmit or receive LLDP frames on this port. If there is
remote systems information which is received on this port and stored in other tables, before the port's
admin status becomes disabled, then the information will naturally age out.
notification
Syntax [no] notification
Context config>port>ethernet>lldp>dstmac
Description This command enables LLDP notifications.
The no form of the command disables LLDP notifications.
To Next Page
Loading...
Need help?
General
