Alcatel-Lucent 7210 SAS M Interface Configuration Guide

Interface Configuration
7210 SAS M, T, X, R6, R12, Mxp Interface Configuration Guide Page 189
report-alarm
Syntax [no] report-alarm [ais] [los] [oof] [rai] [looped] [ber-sd] [ber-sf]
Context config>port>tdm>ds1
config>port>tdm>e1
Description This command enables logging of DS-1 or E-1 alarms for DS-1 or E-1 ports or channels.
The no form of this command disables logging of the specified alarms.
Parameters ais — Reports alarm indication signal errors. When configured, ais alarms are not raised and cleared.
Default ais alarms are issued
los — Reports loss of signal errors. When configured, los traps are not raised and cleared.
Default los traps are issued.
oof — Reports out-of-frame errors. When configured, oof alarms are not raised and cleared.
Default oof alarms are not issued.
rai — Reports resource availability indicator events. When configured, rai events are not raised and
cleared.
Default rai alarms are not issued
looped — Reports looped packets errors.
Default looped alarms are not issued
signal-mode
Syntax no signal-mode {cas}
Context config>port>tdm>ds1
config>port>tdm>e1
Description This command activates the signal mode on the channel.
When enabled, control signals (such as those for synchronizing and bounding frames) are carried in the
same channels as voice and data signals. Configure the signal mode before configuring the Cpipe service to
support T1 or E1 with CAS.
Refer to the 7210 SAS Services Guide, “Creating a Cpipe Service”, for information on configuring a Cpipe
service.
This command is valid when:
• T1 framing is set to esf or sf
• E1 framing is set to g704 or no-crc-g704.
Note: On the 7210 SAS, CAS is enabled at the port level, rather than at the 64 kb/s channel level. This
means that control signals and voice and data signals are all carried in the same channels. However, T1 and
E1 links with a mix of voice and data channels cannot be transported directly across a 7210 SAS network.
For a workaround, please contact Alcatel-Lucent technical service representatives.

Alcatel-Lucent 7210 SAS M Specifications

General

Brand	Alcatel-Lucent
Model	7210 SAS M
Category	Switch
Language	English