LAG Commands
Page 194 7210 SAS M, T, X, R6, R12, Mxp Interface Configuration
Guide
Parameters mode — Specifies the mode in which LACP will operate.
passive — Starts transmitting LACP packets only after receiving packets.
active — Initiates the transmission of LACP packets. administrative-key admin-key — Specifies an
administrative key value to identify the channel group on each port configured to use LACP. This value
should be configured only in exceptional cases. If it is not specified, a random key is assigned.
Values 1 — 65535
system-id system-id — Specifies a 6 byte value expressed in the same notation as MAC address
Values xx:xx:xx:xx:xx:xx or xx-xx-xx-xx-xx-xx
system-priority priority — Specifies the system priority to be used for the LAG in the context of the MC-
LAG.
Values 0 — 65535
lacp-xmit-interval
Syntax [no] lacp-xmit-interval {slow | fast}
Context config>lag
Description This command sepcifies the interval signaled to the peer and tells the peer at which rate it should transmit.
Default fast
Parameters slow — Transmits packets every 30 seconds.
fast — Transmits packets every second.
lacp-xmit-stdby
Syntax [no] lacp-xmit-stdby
Context config>lag
Description This command enables LACP message transmission on standby links.
The no form of this command disables LACP message transmission. This command should be disabled for
compatibility when using active/standby groups. This forces a timeout of the standby links by the peer. Use
the no form if the peer does not implement the correct behavior regarding the lacp sync bit.
Default lacp-xmit-stdby
To Next Page
Loading...
Need help?
General
