Alcatel-Lucent 7210 SAS M Interface Configuration Guide

Interface Configuration
7210 SAS M, T, X, R6, R12, Mxp Interface Configuration Guide Page 207
Values allDef DefRDICCM, DefMACstatus, DefRemoteCCM, DefErrorCCM,
and DefXconCCM
macRemErrXconOnly DefMACstatus, DefRemoteCCM, DefErrorCCM, and
DefXconCCM
remErrXcon Only DefRemoteCCM, DefErrorCCM, and DefXconCCM
errXcon Only DefErrorCCM and DefXconCCM
xcon Only DefXconCCM; or
noXcon No defects DefXcon or lower are to be reported
mac-address
Syntax mac-address mac-address
no mac-address
Context config>eth-ring>path>eth-cfm>mep
Description This command specifies the MAC address of the MEP.
The no form of this command reverts the MAC address of the MEP back to that of the port (if the MEP is on
a SAP) or the bridge (if the MEP is on a spoke SDP).
Parameters mac-address — Specifies the MAC address of the MEP.
Values 6-byte unicast mac-address (xx:xx:xx:xx:xx:xx or xx-xx-xx-xx-xx-xx) of the MEP. Using
the all zeros address is equivalent to the no form of this command.
one-way-delay-threshold
Syntax one-way-delay-threshold seconds
Context config>eth-ring>path>eth-cfm>mep
Description This command enables one way delay threshold time limit.
Default 3 seconds
Parameters priority — Specifies the value for the threshold in seconds.
Values 0 — 600
shutdown
Syntax [no] shutdown
Context config>eth-ring>path>eth-cfm>mep
Description This command administratively enables or disables the MEP.
The no form of this command disables or enables the MEP.

Alcatel-Lucent 7210 SAS M Specifications

General

Brand	Alcatel-Lucent
Model	7210 SAS M
Category	Switch
Language	English