Multi-Chassis Redundancy Commands
Page 210 7210 SAS M, T, X, R6, R12, Mxp Interface Configuration
Guide
Multi-Chassis Redundancy Commands
redundancy
Syntax redundancy
Context config
Description This command allows the user to configure redundancy operations.
multi-chassis
Syntax multi-chassis
Context config>redundancy
Description This command enables the context to configure multi-chassis parameters.
peer
Syntax [no] peer ip-address create
Context config>redundancy>multi-chassis
Description Use this command to configure up to 20 multi-chassis redundancy peers. Note that is is only for mc-lag (20)
not for mc-sync (4).
Parameters ip-address — Specifies the IP address.
Values ipv4-address: a.b.c.d
create — Mandatory keyword specifies to create the peer.
authentication-key
Syntax authentication-key [authentication-key | hash-key] [hash | hash2]
no authentication-key
Context config>redundancy>multi-chassis>peer
Description This command configures the authentication key used between this node and the multi-chassis peer. The
authentication key can be any combination of letters or numbers.
Parameters authentication-key — Specifies the authentication key. Allowed values are any string up to 20 characters
long composed of printable, 7-bit ASCII characters. If the string contains special characters (#, $,
spaces, etc.), the entire string must be enclosed within double quotes.
To Next Page
Loading...
Need help?
General
