EasyManua.ls Logo

Alcatel-Lucent 7210 SAS M - Page 272

Alcatel-Lucent 7210 SAS M
347 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Interface Configuration
7210 SAS M, T, X, R6, R12, Mxp Interface Configuration Guide Page 267
-------------------------------------------------------------------------------
Unicast Packets 9 6
Multicast Packets 469 2
Broadcast Packets 4 2
Discards 0 0
Unknown Proto Discards 0
===============================================================================
===============================================================================
Ethernet-like Medium Statistics
===============================================================================
Alignment Errors : 0 Sngl Collisions : 0
FCS Errors : 0 Mult Collisions : 0
SQE Test Errors : 0 Late Collisions : 0
CSE : 0 Excess Collisns : 0
Too long Frames : 0 Int MAC Tx Errs : 0
Symbol Errors : 0 Int MAC Rx Errs : 0
===============================================================================
*A:SAS-M>config>port#
*A:SAS-M>config>port# /show port 1/1/1 detail
===============================================================================
Ethernet Interface
===============================================================================
Description : 10/100/Gig Ethernet SFP
Interface : 1/1/1 Oper Speed : 100 mbps
Link-level : Ethernet Config Speed : 1 Gbps
Admin State : up Oper Duplex : full
Oper State : up Config Duplex : full
Physical Link : Yes MTU : 9212
Single Fiber Mode : No : Internal
IfIndex : 35684352 Hold time up : 0 seconds
Last State Change : 05/31/2010 11:54:16 Hold time down : 0 seconds
Last Cleared Time : N/A DDM Events : Enabled
Configured Mode : access Encap Type : null
Dot1Q Ethertype : 0x8100 QinQ Ethertype : 0x8100
PBB Ethertype : 0x88e7
Ing. Pool % Rate : 100 Egr. Pool % Rate : 100
Ing. Pool Policy : n/a
Egr. Pool Policy : n/a
Net. Egr. Queue Pol: default Access Egr. Qos *: 1
Egr. Sched. Pol : default Network Qos Pol : n/a
Auto-negotiate : true MDI/MDX : MDI
Accounting Policy : None Collect-stats : Disabled
Egress Rate : Default Max Burst : Default
LACP Tunnel : Enabled
Uplink : No
Split Horizon Group: (Not Specified)
Down-when-looped : Disabled Keep-alive : 10
Loop Detected : False Retry : 120
Use Broadcast Addr : False
Sync. Status Msg. : Disabled Rx Quality Level : N/A
Down On Int. Error : Disabled
CRC Mon SD Thresh : Enabled CRC Mon Window : 10 seconds
CRC Mon SF Thresh : Enabled
Configured Address : 00:25:ba:01:b7:f2

Table of Contents

Other manuals for Alcatel-Lucent 7210 SAS M

Related product manuals