Alcatel-Lucent 7210 SAS M - Page 328

Interface Configuration
7210 SAS M, T, X, R6, R12, Mxp Interface Configuration Guide Page 323
-------------------------------------------------------------------------------
1/1/3 up standby down yes 2 - 32768 no
1/1/5 up standby down 2 - 32768 no
2/1/3 up active up 1 - 32768 no
2/1/4 up active up 1 - 32768 yes
-------------------------------------------------------------------------------
After forcing:
-------------------------------------------------------------------------------
Port-id Adm Act/Stdby Oper Primary Sub-grp Forced Prio Fld-Port
-------------------------------------------------------------------------------
1/1/3 up active up yes 2 active 32768
no
1/1/5 up active up 2 active 32768
yes
2/1/3 up standby down 1 - 32768
no
2/1/4 up standby down 1 - 32768
no
-------------------------------------------------------------------------------
redundancy
Syntax redundancy
Context show
Description This command enables the context to show multi-chassis redundancy information.
multi-chassis
Syntax all
mc-lag peer ip-address [lag lag-id]
mc-lag [peer ip-address [lag lag-id]] statistics
sync peer [ip-address]
sync peer [ip-address] detail
sync peer [ip-address] statistics
Context show>redundancy
Description This command displays multi-chassis redundancy information.
Parameters all — Displays all multi-chassis information.
mc-lag — Displays multi-chassis LAG information.
peer ip-address — Displays the address of the multi-chassis peer.
lag lag-id — Displays the specified LAG ID on this system that forms an multi-chassis LAG configuration
with the indicated peer.