Alcatel-Lucent 7210 SAS M - Page 55

LAG
Page 50 7210 SAS M, T, X, R6, R12, Mxp Interface Configu-
ration Guide
1. VPLS service, SDP to SDP: Test has been performed only for VC label variation with the
same Tunnel label.
2. In the LSR case, incoming labels are used for hashing.
3. ‘Learnt’ wherever mentioned corresponds to Destination MAC.
4. Source/Destination MAC refer to ‘Customer Source/Destination MACs’ unless otherwise
specified
Network port IPv6 interface:
IPv6 network interface to IPv6
network interface
IPv6 unicast traffic: Source and Destination
IP, Source and Destination L4 ports, Ingress
Port-Id.
IES (Multicast IP traffic)
IP interface (Network or SAP) to
IP interface (SAP)
IPv4 Multicast traffic: Source and Destination
IP, Source and Destination L4 ports, Ingress
Port-Id.
Network Port IP interface
(Multicast IP traffic)
IP interface (Network or SAP) to
IP interface (Network)
IPv4 Multicast traffic: Source and Destination
IP, Source and Destination L4 ports, Ingress
Port-Id.
LAG Hashing Fields used for 7210 SAS-M (Network
mode)
Table 7: LAG Hashing mechanism for services configured in Network Mode on 7210 SAS-
M devices
Services and Traffic Direction
(For example: SAP to SDP)
Packet fields used for Hashing for different
traffic types