Alcatel-Lucent 7210 SAS M Interface Configuration Guide

Interface Configuration
7210 SAS M, T, X, R6, R12, Mxp Interface Configuration Guide Page 59
VPLS service:
SDP to SAP
Non-IP traffic (Learnt): Source and
Destination MAC (Outer MACs inside the
payload, just after the MPLS header),
EtherType.
IP traffic (Learnt) : Source and Destination
MAC (Outer MACs inside the payload, just
after the MPLS header), Source and
Destination L4 ports, VLAN
All other (Learnt): Source and Destination
MAC (Outer MACs inside the payload, just
after the MPLS header).
All traffic (Unlearnt): Source and Destination
MAC (Outer MACs inside the payload, just
after the MPLS header), Ingress Port-Id.
Epipe service:
SDP to SAP
Non-IP traffic: Source and Destination MAC
(Outer MACs inside the payload, just after the
MPLS header), EtherType
IP traffic (Learnt) : Source and Destination
MAC (Outer MACs inside the payload, just
after the MPLS header), Source and
Destination L4 ports, VLAN
All other: Source and Destination MAC
(Outer MACs inside the payload, just after the
MPLS header)
VPLS service:
SDP to SDP
All traffic: Source and Destination MAC
(Outer MACs inside the payload, just after the
MPLS header), Ingress Port-Id.
MPLS – LSR All traffic: MPLS label stack (Two labels
deep), Source and Destination IP (only when
IP header immediately follows MPLS header
without any Source and Destination MAC in
between inside the MPLS encapsulation),
Ingress Port-Id.
LAG Hashing Fields used for 7210 SAS-T Network Mode
Services and Traffic Direction Packet fields used for Hashing for different
traffic types

Alcatel-Lucent 7210 SAS M Specifications

General

Brand	Alcatel-Lucent
Model	7210 SAS M
Category	Switch
Language	English