Alcatel-Lucent 7210 SAS M - Page 66

Interface Configuration
7210 SAS M, T, X, R6, R12, Mxp Interface Configuration Guide Page 61
1. VPLS service, SDP to SDP: Test has been performed only for VC label variation with
the same Tunnel label.
PBB Epipe service:
Terminating PBB BEB traffic
(PBB Epipe SAP to B-SAP)
IP traffic: CSA, CDA
L2/non-IP traffic: CSA, CDA, EtherType
IES service (IPv4):
IES SAP to IES SAP
IPv4 unicast traffic: Source and Destination
IP, Source and Destination L4 ports.
IES service (IPv4 Unicast Traffic)
IES SAP to IPv4 network port
interface
IPv4 unicast traffic: Source and Destination
IP, Source and Destination L4 ports, Ingress
Port-ID.
Network Port IPv4 interface
IPv4 network interface to IPv4
network interface
IPv4 unicast traffic: Source and Destination
IP, Source and Destination L4 ports, Ingress
Port-ID.
VPRN service (IP traffic)
SAP to SAP
SDP to SAP
IP traffic: Source and Destination IP, Source
and Destination L4 ports.
VPRN service (IP traffic)
SAP to SDP
IP traffic: Source and Destination IP, Source
and Destination L4 ports, Ingress Port-ID.
IES (Multicast IP traffic)
IP interface (Network or SAP) to IP
interface (SAP)
IPv4 Multicast traffic: Source and Destination
IP, Source and Destination L4 ports, Ingress
Port-Id.
Network Port IP interface
(Multicast IP traffic)
IP interface (Network or SAP) to IP
interface (Network)
IPv4 Multicast traffic: Source and Destination
IP, Source and Destination L4 ports, Ingress
Port-Id.
LAG Hashing Fields used for 7210 SAS-T Network Mode
Services and Traffic Direction Packet fields used for Hashing for different
traffic types