Card, Adapter Card, and Port Command Reference
Page 152 7705 SAR OS Interface Configuration Guide
J0 String The section trace value that is sent to the far-end port
Section Trace
Mode
byte — the section trace in the SONET section header is set in bytes
string — a text string is used to identify the SONET section header
increment-z0 — an incremental STM ID is configured instead of
a static value
Rx S1 Byte The value of the received SONET/SDH S1 byte
Rx K1/K2 Byte The value of the received SONET/SDH K1/K2 byte
Rx J0 String
(Hex)
The hex value of the received J0
Cfg Alarm The type of alarms to be logged and reported for the SONET/SDH port
Alarm Status The current alarm state
BER SD Threshold The configured threshold for line signal degradation BER error rate,
that when crossed determines the signal degradation and signal failure
BER SF Threshold The configured threshold for line signal failure BER error rate, that
when crossed determines the signal degradation and signal failure
Hold time up The hold-timer value for link-up event dampening
Hold time down The hold-timer value for link-down event dampening
Port Statistics
Packets
input/output
The number of packets, delivered by this sub-layer to a higher (sub-)
layer, which were not addressed to a multicast or broadcast address at
this sub-layer. The total number of packets that higher-level protocols
requested be transmitted, and which were not addressed to a multicast
or broadcast address at this sub-layer, including those that were
discarded or not sent.
Discards
input/output
The number of inbound packets chosen to be discarded to possibly free
up buffer space
Unknown proto
discards
input/output
For packet-oriented interfaces, the number of packets received at the
interface that were discarded because of an unknown or unsupported
protocol. For character-oriented or fixed-length interfaces that support
protocol multiplexing, the number of transmission units received at the
interface that were discarded because of an unknown or unsupported
protocol. For any interface that does not support protocol multiplexing,
this counter will always be 0.
Table 14: Show Specific Port Output Fields (SONET/SDH Port) (Continued)
Label Description
To Next Page
Loading...
