Alcatel-Lucent 7705 - Adapter Cards

7705 SAR Interfaces
7705 SAR OS Interface Configuration Guide Page 101
SONET/SDH Path Commands
path
Syntax [no] path [sonet-sdh-index]
Context config>port>sonet-sdh
Description This command defines the SONET/SDH path.
The no form of this command removes the specified SONET/SDH path.
Default no index
Parameters sonet-sdh-index — specifies the components making up the specified SONET/SDH path
On the 4-port OC3/STM1 Clear Channel Adapter card, sonet-sdh-index is optional; if used, the
value must be sts3.
Syntax: sts1-x.x
crc
Syntax crc {32}
Context config>port>sonet-sdh>path
Description This command specifies a cyclic redundancy check on the SONET/SDH path.
Default 32
(the default is 32 when the encap-type is set to ATM; this default cannot be changed)
Parameters 32 — use 32 bit checksum for the associated port/channel