Card, Adapter Card, and Port Command Reference
Page 170 7705 SAR OS Interface Configuration Guide
Table 18: Show Port Detail Output Fields (TDM DS1 Interface)
Label Description
Description A text description of the port
Interface The port ID displayed in the slot/mda/port format
Type The type of interface
Admin Status Up — the port is administratively up
Down — the port is administratively down
Physical Link Yes — a physical link is present
No — a physical link is not present
Signal Mode The port signaling mode
Last State Change The last time that the operational status of the port changed state
Loopback The port loopback mode
Remote Loop respond The DS1 channel response to remote loopbacks
Load-balance-algo The load balance algorithm used on the port
Cfg Alarm The type of alarms to be logged and reported for the port
Alarm Status The current alarm state
Hold time up The hold-timer value for link-up event dampening
Hold time down The hold-timer value for link-down event dampening
Framing The DS1 framing to be used for the port
Oper Status up — the port is operationally up
down — the port is operationally down
Clock Source adaptive-timed — clocking is derived from the
incoming pseudowire packets
loop-timed — the link recovers the clock from the received
data stream
node-timed — the link uses the internal clock when
transmitting data
Channel IfIndex The channel interface index number
In Remote Loop Specifies whether incoming remote loopback is enabled
Egr. Sched. Pol The egress scheduling policy
Traffic Statistics Traffic statistics
To Next Page
Loading...
