Common Configuration Tasks
Page 56 7705 SAR OS Interface Configuration Guide
Use the config port info command to display port configuration information.
ALU-A>config>port# info
----------------------------------------------
description "Ethernet access port"
ethernet
mode access
encap-type dot1q
exit
no shutdown
----------------------------------------------
ALU-A>config>port#
Configuring Channelized Ports
Channelized ports are supported on the 16-port T1/E1 ASAP Adapter card. Ethernet ports
and OC3/STM1 ports cannot be channelized.
When configuring channelized ports, the port ID is specified in different ways depending on
the TDM type and level of channelization, as follows:
N × DS0 in DS1port.channel-group, where channel-group is {1 to 24}
N × DS0 in E1port.channel-group, where channel-group is {1 to 32}
Verifying the Adapter Card Type
To ensure that you have a channel-capable adapter card, verify the adapter card you are
configuring by entering a show mda
slot-id command.
In the following example, MDA 3 and MDA 4 show a channelized DS1 adapter card.
*A:7705:Dut-C# show mda
===============================================================================
MDA Summary
===============================================================================
Slot Mda Provisioned Equipped Admin Operational
Mda-type Mda-type State State
-------------------------------------------------------------------------------
1 1 a4-oc3 up provisioned
2 a4-oc3 up provisioned
3 a16-chds1 a16-chds1 up up
4 a16-chds1 a16-chds1 up up
5 a8-eth a8-eth up up
6 a8-eth a8-eth up up
===============================================================================
*A:7705:Dut-C#
To Next Page
Loading...
