Card, Adapter Card, and Port Command Reference
Page 202 7705 SAR OS Interface Configuration Guide
PPP Input Discards : N/A Primary Member Port: None
Mode : access
===============================================================================
Traffic Statistics
===============================================================================
Input Output
-------------------------------------------------------------------------------
Octets 0 0
Packets 0 0
Errors 0 0
===============================================================================
Port Statistics
===============================================================================
Input Output
-------------------------------------------------------------------------------
Unicast Packets 0 0
Multicast Packets 0 0
Broadcast Packets 0 0
Discards 0 0
Unknown Proto Discards 0
===============================================================================
*A:ALU-1>#
Note: The ima-grp detail command shows all bundles in the IMA group. The bundle-ima
detail command shows information on the specified bundle. The fields for both commands
are the same.
Table 34: Show Multilink Bundle MLPPP Output Fields
Label Description
Bundle Id The port ID for this bundle
Type The type of this multilink bundle:
mlppp — the bundle is of type MLPPP
Admin State Up — the bundle is administratively up
Down — the bundle is administratively down
Oper State Up — the bundle is operationally up
Down — the bundle is operationally down
Port State The state level of the port:
none — the port is either in its initial creation state or is just about to
be deleted
ghost — no member links are configured as part of this bundle
down — all member links are in “none”, “ghost”, or “down” state
To Next Page
Loading...
