Alcatel-Lucent 7705 - Common Configuration Tasks; Configuring Cards and Adapter Cards

Common Configuration Tasks
Page 50 7705 SAR OS Interface Configuration Guide
Common Configuration Tasks
The following basic system tasks must be performed.
• Configuring Cards and Adapter Cards
→ Configuring Adapter Card Network Parameters
→ Configuring Adapter Card Clock Mode
→ Configuring Adapter Card Fabric Port Counters
→ Configuring Adapter Card Fabric Profile
• Configuring Ports
→ Configuring Ethernet Port Parameters
→ Configuring Channelized Ports
→ Configuring SONET/SDH Port Parameters
→ Configuring ATM Interface Parameters
→ Configuring Multilink PPP Bundles
→ Configuring Multilink ATM Inverse Multiplexing (IMA) Groups
Configuring Cards and Adapter Cards
Card configurations must include a chassis slot designation. A slot must be preconfigured
with the type of card and adapter cards that are allowed to be provisioned.
The following CLI syntax shows an example of configuring a chassis slot and card (to
activate the IOM) and adapter card.
Example: ALU-1>config# card 1
ALU-1>config>card# card-type iom-1g
ALU-1>config>card# mda 1
ALU-1>config>card>mda# mda-type a4-oc3
ALU-1>config>card>mda# exit
ALU-1>config>card# mda 2
ALU-1>config>card>mda# mda-type a4-oc3
ALU-1>config>card>mda# exit
ALU-1>config>card# mda 3
ALU-1>config>card>mda# mda-type a16-chds1
ALU-1>config>card>mda# exit
ALU-1>config>card# mda 4
ALU-1>config>card>mda# mda-type a16-chds1
ALU-1>config>card>mda# exit
ALU-1>config>card# mda 5
ALU-1>config>card>mda# mda-type a8-eth
ALU-1>config>card>mda# exit