Alcatel-Lucent 7705 - 1.0;2.3 Mini-Coaxial Distribution Panel

7705 SAR Interfaces
7705 SAR OS Interface Configuration Guide Page 53
Configuring Adapter Card Fabric Profile
Use the following CLI syntax to assign a fabric profile on an adapter card.
CLI Syntax: config>card>mda#
mda-type {a16-chds1|a8-eth|a8-ethv2|a4-oc3}
[no] fabric-stats-enabled
network
ingress
fabric-policy <fabric-policy-id>
queue-policy <name>
access
ingress
fabric-policy <fabric-policy-id>
no shutdown
Configuring Ports
This section provides the CLI syntax and examples to configure the following:
• Configuring Ethernet Port Parameters
→ Ethernet Network Port
→ Ethernet Access Port
• Configuring Channelized Ports
→ Verifying the Adapter Card Type
• Configuring SONET/SDH Port Parameters
→ SONET/SDH Access Port
• Configuring ATM Interface Parameters
→ ATM Interface Commands
• Configuring Multilink PPP Bundles
• Configuring Multilink ATM Inverse Multiplexing (IMA) Groups
→ IMA Groups
→ Configuration Notes
→ IMA Test Procedure